Neat Image - Guide de l'Utilisateur / Profils de Bruit de Dispositif / Building
profile for specific device mode / Using
the Calibration Target
Étape 2. Preparing a shot or scan of the Calibration Target
Case of digital camera
Use the displayed or printed Calibration Target to prepare a test shot for building
a device noise profile for your camera:
- Set the camera to a specific shooting mode (ISO level, etc.) you want to
build a profile for;
- Important: set the focusing system on infinity (you have to get an out of
focus image);
- Make sure the Calibration Target fills the whole frame and make a shot;
- Open the resulting shot in Neat Image; see the Step
3. Opening the image.
Case of flatbed scanner
Use the printed Calibration Target to prepare a test scan for building a device
noise profile for your flatbed scanner:
- Set the scanner to a specific scanning mode (resolution, light level, etc.)
you want to build a profile for;
- If possible set the scanner out of focus (an out of focus scan is preferred
for profiling); a possible way to achieve this is to raise the page over the
scanner glass a bit;
- Scan the printed Calibration Target;
- Open the resulting scan in Neat Image; see the Step
3. Opening the image.
Case of slide scanner
Use the displayed or printed Calibration Target to prepare a test scan for
building a device noise profile for your film scanner:
- Set the camera to a specific shooting mode (film type, exposure, etc.) you
want to build a profile for;
- Important: set the focusing system on infinity (you have to get an out of
focus image);
- Make sure the Calibration Target fills the whole frame and make a shot;
- Develop the slide and put it into the scanner;
- Set the scanner to a specific scanning mode (resolution, light level, etc.)
that you want to build a profile for and scan the slide;
- Open the resulting scan in Neat Image; see the Step
3. Opening the image.
Étape 1 :: Étape 2
:: Étape 3 :: Étape
4 :: Étape 5
Copyright © Alex64 - 1998-2011 http://alex64.free.fr