Neat Image - Guide de l'Utilisateur / Profils de Bruit de Dispositif / Building
profile for specific device mode / Using
the Calibration Target
Étape 1. Preparing the Calibration Target
There are two ways to use the Calibration Target: you can open it on the screen
and take a shot (with a digital or traditional camera, depending on your workflow)
or you can print it out and then shoot or scan the hardcopy.
Shooting the Calibration Target off the screen is faster, especially with a
digital camera. However, be careful when shooting it off the screen of a CRT
monitor because you may occasionally capture scan bands. These bands may spoil
a part of the shot. If you cannot avoid these bands, prepare a printed version
of the Calibration Target or shot it off the LCD monitor, which does not produce
this effect.
Case of shooting the Calibration Target off the screen
- Click
(the Calibration
Target button) or select the Tools | Calibration
Target
menu item; the Profiling with Calibration
Target popup window (see on the right) will open;
- Click
(the Display
target
button) in the popup window;
- Use the displayed Calibration Target in the Step
2. Preparing a shot or scan of the Calibration Target.
Case of shooting the printed Calibration Target
- Click
(the Calibration
Target button) or select the Tools | Calibration
Target
menu item; the popup window will open;
- Click
(the Save
target
button) and select a name for a *.BMP
file to save the image of the Calibration Target to;
- Open the saved BMP image of the Calibration Target in your image editor
and print out the image on a sheet of white matte paper; make sure the image
fills the whole page;
- Use the printed target in the Step
2. Preparing a shot or scan of the Calibration Target.
Étape 1 :: Étape
2 :: Étape 3 :: Étape
4 :: Étape 5
Copyright © Alex64 - 1998-2011 http://alex64.free.fr